- 您现在的位置：买卖IC网 > Sheet目录477 > MIC2807-OOYML TR (Micrel Inc)IC PWR MANAGEMENT RF PA 17-MLF
V OUT ? ? 1 ? OUT ? ?
I PK = I OUT +
Micrel, Inc.
Component Selection
Output Capacitor
LDO1 output requires a 2.2μF ceramic capacitor, while
the LDO2 and DC/DC regulator outputs require a 1μF
ceramic capacitor. All output capacitor values can be
increased to improve transient response, but perform-
ance has been optimized for a 2.2μF ceramic capacitor
for LDO1 and 1μF ceramic capacitors for both the
DC/DC regulator and LDO2. X7R/X5R dielectric-type
ceramic capacitors are recommended because of their
temperature performance. X5R/X7R-type capacitors
change capacitance by 15% over their operating
temperature range and are the most stable type of
ceramic capacitors. Z5U and Y5V dielectric capacitors
change value by as much as 50% to 60% respectively
over their operating temperature ranges.
Input Capacitor
For optimal bypassing a minimum 1μF ceramic, 2.2μF
recommended, should be placed as close as possible to
MIC2807
Inductor Selection
The MIC2807 is designed for use with a 4.7μH inductor.
Proper selection should ensure that the inductor can
handle the maximum average and peak currents
required by the load. Maximum current ratings of the
inductor are generally given in two methods; permissible
DC current and saturation current. Permissible DC
current can be rated either for a 40°C temperature rise
or a 10% to 20% loss in inductance. Ensure that the
inductor selected can handle the maximum operating
current. When saturation current is specified, make sure
that there is enough margin, so that the peak current will
not saturate the inductor. Peak inductor current can be
calculated as follows:
? V ?
? V IN ?
2 × f × L
I PK : Peak Inductor Current
I OUT : Output/Load Current
the VIN pin. X5R or X7R dielectrics are recommended
for the input capacitor. Y5V dielectrics lose most of their
capacitance over temperature and are therefore, not
recommended. For high frequency filtering a minimum
1μF is recommended close to the VIN and PGND pins.
Smaller case size capacitors are recommended due to
their lower ESR and ESL. Please refer to the PCB layout
section for an example of an appropriate circuit layout.
February 2008
14
V IN :
V OUT :
f:
L:
Input Voltage
Output Voltage
Switching Frequency of PWM Regulator
Inductor Value
M9999-022008-B
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
MIC2808-NNYFT TR
IC RF PA SOLUTION 600MA 16-FTMLF
MIC94030BM4 TR
MOSFET P-CH 16V 1A SOT-143
MIC94053BC6 TR
MOSFET P-CH 6V 2A SC70-6
MICRF001BM
IC RECEIVER/DATA MOD 14-SOIC
MICRF007BM TR
IC RECEIVER UHF 300MHZ 8-SOIC
MICRF008YM TR
IC RECEIVER 300-440MHZ 8-SOIC
MICRF009BM TR
IC RCVR UHF 300-440MHZ 16-SOIC
MICRF010BMTR
IC RCVR UHF 300-440MHZ 8-SOIC
相关代理商/技术参数
MIC280-7YM6
制造商:Rochester Electronics LLC 功能描述: 制造商:RF Micro Devices Inc 功能描述:
MIC280-7YM6 TR
功能描述:板上安装温度传感器 12-bit Local and Remote +/-4% -55 C to +125 C I2C Temperature Sensor in SOT23-6
RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor
MIC2808-NNYFT TR
功能描述:直流/直流开关调节器 RF PA Power Solution, Single 600mA Buck & Dual Low Noise LDO
RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5
MIC2808-NNYFT-TR
功能描述:RF IC Power Management CDMA, W-CDMA, WLL 2MHz 2.7V ~ 5.5V Supply 16-TMLF? 制造商:microchip technology 系列:- 包装:剪切带（CT） 零件状态:过期 功能:电源管理 频率:2MHz RF 类型:CDMA，W-CDMA，WLL 辅助属性:2.7 V ~ 5.5 V 电源 封装/外壳:16-UFDFN，16-TMLF? 供应商器件封装:16-TMLF? 标准包装:1
MIC2810-1JGMYML TR
功能描述:线性稳压器 - 标准 DC-DC + 2 Linear Regulators with LowQ mode and POR (Lead-Free)
RoHS:否 制造商:STMicroelectronics 输出类型: 极性: 输出电压:1.8 V 输出电流:150 mA 负载调节: 最大输入电压:5.5 V 线路调整率: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOT-323-5L
MIC2810-44MYML
制造商:Rochester Electronics LLC 功能描述: 制造商:RF Micro Devices Inc 功能描述:
MIC2810-44MYML TR
功能描述:线性稳压器 - 标准 DC-DC + 2 Linear Regulators with LowQ mode and POR (Lead-Free)
RoHS:否 制造商:STMicroelectronics 输出类型: 极性: 输出电压:1.8 V 输出电流:150 mA 负载调节: 最大输入电压:5.5 V 线路调整率: 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:SOT-323-5L
MIC2810-44MYML-TR
功能描述:Linear And Switching Voltage Regulator IC 3 Output Step-Down (Buck) (1), Linear (LDO) (2) 2MHz 16-VFQFN, 16-MLF? 制造商:microchip technology 系列:- 包装:剪切带（CT） 零件状态:停产 拓扑:降压（降压）（1），线性（LDO）（2） 功能:任何功能 输出数:3 频率 - 开关:2MHz 电压/电流 - 输出 1:1.2V，600mA 电压/电流 - 输出 2:1.2V，300mA 电压/电流 - 输出 3:2.8V，300mA 带 LED 驱动器:无 带监控器:无 带定序器:无 电压 - 电源:1.65 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:16-VFQFN，16-MLF? 供应商器件封装:16-MLF?（4x4） 标准包装:1